These bars represent volume levels, so if you
imagine the signal travelling from Left to Right, as
it hits a bar, the volume level of that bar is
applied to it. If the bar is all the way at the top,
the volume level is full, likewise all the way down
it is off. There are also tempo in BPM, and Note
duration. BPM is set by the host DAW, and if there
is no DAW, then it is set to 120. The Note duration
is Whole Note, Quarter Note, Half Note, etc.
There is also a Sweeping filter This is the Standard
AcmeBarGig adjustable filter. Low Pass, High Pass,
Band Pass etc are all selectable. The delay from DIG
is also present in the TranceGate
You can get some very interesting Rythmical patterns
using a TranceGate, as well as some interesting solo
sounds
Visit:
AcmeBarGig
